Make A Homemade Bong In Minutes.
Making A Bong Is Easy! Learn How
To Build A Gravity Bong
You can make a homemade bong out of a variety of materials. Making a bong is easy once you have the needed tools. In this page we will show you how to make a gravity bong.
WHAT IS A GRAVITY BONG?
A gravity bong is an easy to make homemade bong. Gravities rely on the reverse suction of air through a plastic bottle submerged in a bucket filled with water. Gravity bongs aren't quite like a tradtional bong. Gravities use the water to create suction when pulling up the fresh bottle of smoke. A traditional bong uses the water as a filter.
NOTE: Gravity bongs produce hits that are very, very potent. This smoking method is only reccommended for seasoned smokers.
An Easy Homemade Bong (Gravity Bong)
Gravity
bong materials:1. 1 Empty gallon milk jug or two liter soda bottle.
2.
A bowl
piece from bong, or
small metal socket or socket wrench.
We wouldn't reccommend using other materials for the bowl piece.
However, if you think that your parts to make a bong in alternative are harmless, meaning it will not melt, and does not produce harmful toxins, then proceed with good judgement.
3.
Bucket,
scissors, or knife, screwdriver, lighter,
some nugs to smoke.
Making a gravity bong Steps:
1.
Gather needed materials,
and prepare
for a super
intense rip.
2.
Completely remove the
bottom of
your bottle with
scissors or a knife.
In this case we used a knife. Be careful not to cut the bottle too short. Cut only the bottom off.
3. Heat up the tip of the screwdriver until considerably hot and push through the cap of your bottle.
4.
Now
quickly and CAREFULLY
heat that small hole with your lighter to soften
it up. No more than
a second or
two should be fine, now
slide your cap
around your bowl piece, socket, or other piece to hold your weed in the
combustion process of smoking.
5.
Pack
yourself some nug
in that bowl piece, fill up your bucket with
water,
and submerge your
bottle until the top is the only part out of the
water.
6. Cap the bottle off while it's submerged, then Light the flame above the bong and slowly begin to pull the bottle up. If you aren't getting any airflow through the bowl, it may be packed too tight. Next time, Repack your bowl a little looser.
7.
Continue
to burn your bowl until the nug is
snapped
through, or the bong is filled with smoke.
NEVER PULL YOUR GRAVITY BONG OUT OF THE WATER WHEN COMPLETELY FILLED WITH SMOKE!!!
Hold the bong steady, it is filled with smoke!
Keep the bottom of the bong submerged in the water, or you will lose all your smoke.
Take the cap off while still holding it steady, cover it with your mouth, and inhale as you suck the bong back into the bucket of water.
BEWARE!
THIS MAY BE THE FATTEST, DANKEST,
MOST POTENT RIP YOU'VE EVER TAKEN!